Description

5'7.5" Lost "The Ripper" 27.65L Used Surfboard #47429 Vendor: Lost Model Name: The Ripper City: San Clemente Condition: Used Length: 5'7.5" Width: 19.13" Thickness: 2.34" Volume: 27.65L Fins: FCS II - 5 boxes (not included) Construction: Poly Description: Check photos for visual of pressures on the deck and bottom. The deck has very light back foot pressures. The bottom has very light glass blemish behind the left quad rear box that is water tight. The left rail has a small shatter towards the nose that is not water tight and a few other light surface scratches towards the tail that are water tight. The right rail also has some light scratches that are water tight. The tail has quite a bit of light surface scratches, a scratch that is not water tight, and a few small under glass shatters that are water tight. The nose has some light surface scratches that are water tight. Don't understand the surfboard description lingo? Go to our Glossary of Terms. More Information: From the Lost site: The RIPPER! A rip-roaring, radically fun, small wave slasher, carved out from the ridiculously popular Rad Ripper. A board designed to violently shred everyday, average surf and leave neon '80s nostalgia dying on the sand. The RIPPER was inspired by Kolohe Andino, whose love for (and performances on) the Rad Ripper are undeniable. Admittedly addicted to the Rad Ripper, Kolohe requested adjustments that would eliminate the nostalgic '80s influences and create a more modern look with less emphasis on revivalism, resulting in an all-new small wave shred sled. To achieve this, we removed the beak nose and re-foiled the entire deck line, abandoning the flat deck and steep rails for a more contemporary, moderately rolled rail and deck. The tail is scooped out with a thinner, boxy block. We removed the deep fluted wing, leaving behind a subtle bump/hip, but retained plenty of small wave surface area. The nose is slightly pulled, with a touch more rocker, to fit just a bit better into kinky transitions. Like its forefather, the Rad Ripper, The RIPPER retains an overall low rocker with a single concave center and a deep double concave/vee that runs through the fins and out the tail. The built-in speed, paddle-ability, and firm carving control that defined the Rad Ripper are integrated into this update. The RIPPER loves to be surfed aggressively, off the tail. The low rocker and wide tail block relish rear foot pressure, driving, snapping, and carving harder the more aggressively it's ridden. More modest or casual surfers will also enjoy its built-in speed and the ease of directional changes enabled by the double concave vee. The rolled deck, lower/softer rails, increased nose rocker, and reduced nose area, combined with a more blended tail outline and scooped out deck, all work together to modernize and unleash The RIPPER, out of the shadows and into the limelight. The RIPPER is a small wave weapon for hacking and lacerating minuscule to moderate surf, under the feet of both average Joes and pumped-up pros. Ride about the same size as your original Rad Ripper but with a touch less foam for a cheeky feeling or easily go a bit longer if you want to cruise and enjoy. Price: $650.00